| Part No. | Size | Type | F1 (N)i | Stroke (mm)i | Total L (mm)i | Thread | Material | In stock | Price / pc Ex. VAT | |
|---|---|---|---|---|---|---|---|---|---|---|
| Loading springs… | ||||||||||
How to Choose the Right Gas Spring
Measure the distance between mounting points when fully open (extended length) and the piston rod travel between the retracted and extended positions (stroke).
The force depends on the weight, centre of gravity, lever arm and number of gas springs. The required force must be calculated from your full installation geometry — our configurator helps you find the right spring once you know it.
The end fitting type determines how the gas spring connects to your structure. Available types: ball joints, ball sockets, clevis ends, end bearings, extension rods, eye ends and axial joints — all can be added separately.
Install with the piston rod pointing downward where possible — this keeps internal oil near the seal. Keep the rod clean and free from damage.
Compression springs extend the piston rod automatically and support lifting. Traction springs pull the rod inward and are used where a pulling force is needed. Locking gas springs can be held in any position and released via a trigger.
Available end fittings: ball joints, ball sockets, clevis ends, end bearings, extension rods, eye ends and axial joints. Ball joints and axial joints compensate for small angular misalignments during movement. Fittings attach directly to flaps, frames and housings.
Gas springs are pressurised components. Never open, drill, heat or mechanically modify them. Replace any spring with significant force loss or visible leakage. Dispose of defective gas springs correctly as they contain gas and lubricant.